System Disc (/System)

                                Release 5.0.0
                             Part No. 00095-12063
                     (copyright Hewlett Packard Co., 1985)


     Introduction
     ------------
     This disc contains miscellaneous files which may be of use to you for
     optional equipment and application software available for the HP Integral
     PC.  Also included are some simple upgrade procedures for application
     s/w you may have purchased from HP for the earlier operating system
     release (HP-UX/RO 1.0.0).  Hewlett-Packard has made every attempt to make
     this operating system upgrade as easy and natural as possible.  Most
     application discs will run "as is" without need for change.

     Contents
     --------
     A set of loadable s/w drivers for optional h/w equipment are provided
     on this disc.  Associated with each loadable driver are three seperate
     files.  These consist of a load utility program, a driver data file and a
     manual page.  The manual pages should be consulted for more information
     on each driver.  The following is a list of the files on this disc.

        load_modem            Program used to load the s/w driver for the
                              82915A 300/1200 bps Modem Card.

        modem.data            Data file for the `load_modem' program.

        load_modem.doc        Manual page for `load_modem' utility.  Located
                              in `documents' folder.

        load_plot             Program used to load the s/w driver for HP
                              plotters connected through the Serial Interface.
                              For use with the 5.0.0 ROM set only.

        plot.data             Data file for the `load_plotter' program.

        load_plot.doc         Manual page for `load_plotter' utility.  Located
                              in `documents' folder.

     Operation
     ---------
     All programs on this disc are prefixed with `load_'.  Each can be executed
     by simply typing the program name to PAM, or by highlighting the program
     name and pressing [Start] (ie., the key [f1]).  Each program will create
     a window and indicate when the loading operation is complete and the
     driver is ready for use.

     All manual pages have the suffix `.doc' .  Manual pages can viewed or
     printed by using the PAM view or print command, or by simply directing the
     manual page to the printer (e.g., 'load_modem.doc >/dev/lp').

     Copying Files
     -------------
     Although, the `load_...' utilities can be used directly from this
     disc, you may find it useful to copy them to other discs depending
     upon your application.  This is easily accomplished by using the copy
     command in PAM.  When copying a 'load_..."  utility, be sure to also
     copy the appropriate data file.  For example, to copy the software
     for the modem card to a new disc, you must copy both the `load_modem'
     and the `modem.data' files. The manual page for each utility lists the
     associated files required for that utility to operate.  The manual page
     file, itself, need not be copied.

     DATACOMM and MODEM Product Upgrade
     ----------------------------------
     The DATACOMM disc which comes with the MODEM product contains loadable
     s/w drivers for both the SERIAL and MODEM cards.  The HP-UX/RO 5.0 release
     contains the serial driver in rom, thus no change is required for SERIAL
     card users.  The MODEM driver, however, which is supplied on this disc has
     been upgraded to operate with both operating system releases, (version 1.0
     and version 5.0).  To upgrade your DATACOMM disc for modem, copy the
     `load_modem' and `modem.data' files to your working DATACOMM disc. Then
     proceed as normal.  See "Copying Files" discussion immediately above.